beautypg.com

Tion, Before operation -17, Installation of print paper -13 – MITSUBISHI ELECTRIC CP9500DW User Manual

Page 15: Before operation, Installation of print paper

background image

12

CONNECTIONS

OTHERS

PRECAUTIONS

FEA

TURES

PREP

ARA

TION

TROUBLE-

SHOOTING

CONTENTS

BEFORE OPERATION

Before printing,

1

1

1

1

1

Install the print paper to this unit. (See below.)

2

2

2

2

2

Install the ink ribbon to this unit. (page 14-15)

INSTALLATION OF PRINT PAPER

Spacers

2

The spacers are attached to the paper flanges. For the necessity of

the spacers, see the Quick Setup Guide.

Remove the cushions put between the paper flange and spacer when

use them.

How to attach and remove the spacers

1. Turn the spacer until the latches are unlocked.

2. Remove the spacer with the paper flange’s stoppers retracted.

When you use the print paper with which the spacers have to be

used, attach the spacers to the paper flanges by reversing the above-

mentioned removal procedure as shown right.

Spacer

latches

Paper
flange

1

1

1

1

1

Attach the supplied paper flanges to both sides of the print paper.

When you pinch the latches on the paper flange, the stoppers retract into the shaft.

Attach the flanges to the print paper with the stoppers retracted.

Make sure that the flanges are attached to the print paper securely, and release the

latches.

NOTE

Take care not to pinch your fingers.

Do not remove the sticker on the print paper yet.

Do not slacken the paper. Any slack in the print paper may degrade the print quality.

NOTE

When placing the print paper, remove one flange and keep the print paper upright

on its side with no flange.

When you put the print paper sideways, it may roll and fall. This may cause injury.

NOTE

Do not touch the thermal head.

Fingerprints or dust on the thermal head will degrade the print quality.

Sticker

INCORRECT

CORRECT