MTD YM26CS EN - Manual (Page 18)

18
SECTION 7: MAINTENANCE AND REPAIR INSTRUCTIONS
2. Pull out the bump knob, spring and foam seal
(Fig. 22).
3. Pull the inner reel with existing line from the outer
spool (Fig. 23).
4. Remove any existing line from the inner reel before
cleaning. Remove any debris or grass from the knob,
spring, inner reel and foam seal. Wash the inner reel
(Fig. 25) with warm soapy water.
Inner Reel
Shaft
Plunger
NOTE: The inner reel must be totally dry before
reinstalling it into the outer spool. Do not
lubricate the inner reel or outer spool assembly.
6. Place the inner reel into the outer spool.
7. Place the bump knob, spring and foam seal into the
inner reel (Fig. 22).
8. Press the bump knob down and tighten clockwise.
9. Install new line as described in Line Installation for
the SpeedSpool ® in the Maintenance and Repair
Instructions section.
5. Clean the shaft and the inner surface of the outer
spool. To clean the shaft underneath the plunger,
press down on the plunger (Fig. 26). Remove any dirt
or debris from the shaft.
Fig. 24
Fig. 26
Fig. 25
CLEANING THE SPEEDSPOOL ®
Cleaning the SpeedSpool ® may be necessary:
• To remove jammed or excess line, or
• If the SpeedSpool ® becomes difficult to wind or
does not operate correctly when bumping the head
on the ground.
1. Hold the outer spool, and unscrew the bump knob
counterclockwise (Fig. 24).
SPEEDSPOOL ® REPLACEMENT PARTS
Replacement Line . . . . . . . . . . . . . . . . . . . . 791-181472
Replacement Line Cartridge . . . . . . . . . . . 791-181460B
Inner Reel Spring . . . . . . . . . . . . . . . . . . . . 791-181465B
Foam Seal . . . . . . . . . . . . . . . . . . . . . . . . . . 791-181467
Inner Reel . . . . . . . . . . . . . . . . . . . . . . . . . 791-181460B
Bump Head ™ Knob Assembly . . . . . . . . . 791-181468B
(Bump Head ™ , Inner Reel, Spring, )
These SpeedSpool ® replacement parts can be
purchased from your local authorized dealer.