MTD YM26CS EN - Manual (Page 13)

SECTION 6: OPERATING INSTRUCTIONS
13
OPERATING THE EZ-LINK ™ SYSTEM
The EZ-Link ™ system enables the use of these
optional add-ons.
Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . HS720r
Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . ST720r
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . SS725r
Sweeper/Blower . . . . . . . . . . . . . . . . . . . . . . . . . SB720r
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r
WARNING: Read and understand operator’s
manual for add-on prior to operation.
Removing the Cutting Attachment or Add-Ons:
1. Turn the knob counterclockwise to loosen (Fig. 11).
2. Press and hold the release button (Fig. 11).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link
™
coupler (Fig. 12).
Installing the Cutting Attachment or Add-Ons:
WARNING: To avoid serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1. Turn knob counterclockwise to loosen (Fig. 11).
Fig. 11
EZ-Link™ Coupler
Release Button
Guide Recess
Knob
Release
Button Hole
Upper Shaft Housing
EZ-Link ™ Coupler
2. While firmly holding the add-on, push it straight into
the EZ-Link ™ coupler (Fig. 12).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 11).
3. Turn the knob clockwise to tighten (Fig. 11).
Fig. 12
Lower Shaft Housing
Release Button