Milan Technology MIL-140TRM User Manual
Milan Technology Satellite
Installation Guide: MIL-140TRM
® Copyright 1998 MiLAN Technology Printed in the USA P/N: 90000111 Rev. B
Regulator y Approvals
•
FCC Class A
•
UL 1950
•
CSA C22.2 No. 950
•
EN60950
•
CE
–
EN55022
Class B
– EN50082-1
Canadian EMI Notice
This Class A digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment
Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur
du Canada.
European Notice
Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage
Directive (73/23/EEC) issued by the commission of the European Community. Compliance with these
directives implies conformity to the following European Norms:
•
EN55022 (CISPR 22) - Radio Frequency Interference
•
EN50082-1 (IEC801-2, IEC801-3, IEC801-4) - Electromagnetic Immunity
•
EN60950 (IEC950) - Product Safety
Trademarks
MiLAN Technology™ is a trademark of MiLAN Technology. All other products and brands are the
trademarks of their respective holders. All rights reserved.
To Contact MiLAN
For prompt response when calling for service information, have the following information ready:
•
Product serial number and rev.
•
Date of purchase
•
Vendor or place of purchase
You can reach MiLAN technical support at 408/744-2751
Or E-mail at:
Address:
1299 Orleans Drive
Sunnyvale, CA 94089
Voice:
408/744-2775
Fax:
408/744-2793
Web:
www.milan.com
MIL-140CRM and MIL-140TRM
10BASE-FL to 10BASE-T
Media Converter for MiLAN's
Media Conversion System
Installation Guide
This guide includes the following:
• “Introduction” on page 2
• “Installation” on page 3
• “MDI-X/MDI” on page 3
• “Link Sentry Configuration” on page 5
• “Indicators” on page 6
Five-Year Limited Warranty
MiLAN Technology warrants to the original consumer or purchaser that each of its products,
and all components thereof, will be free from defects in material and/or workmanship for a
period of five years from the original factory shipment date. Any warranty hereunder is
extended to the original consumer or purchaser and is not assignable.
MiLAN Technology makes no express or implied warranties including, but not limited to, any
implied warranty of merchantability or fitness for a particular purpose, except as expressly set
forth in this warranty. In no event shall MiLAN Technology be liable for incidental or
consequential damages, costs, or expenses arising out of or in connection with the performance
of the product delivered hereunder. MiLAN Technology will in no case cover damages arising
out of the product being used in a negligent fashion or manner.
TP
ACT
MIL-
140TRM
FX
LINK
TP
LINK
FX
ACT
MDI-X MDI
10BASE-T
10BASE-FL
Thumbscrews
TX
RX
Document Outline
- Five-Year Limited Warranty
- MIL-140CRM and MIL-140TRM
- 10BASE-FL to 10BASE-T
- Media Converter for MiLAN's
- Media Conversion System
- Installation Guide
- About this Manual
- Introduction
- Features
- Indicators
- Specifications
- Installation
- 1. Make any configuration changes to the module (i.e., DIP switch settings).
- 2. Remove the screws securing the faceplate and remove it from the chassis.
- 3. Slide the module into the slot through the guide rails.
- 4. Insert the module into the card-edge connector (port bay). Make sure it is seated firmly.
- 5. Secure the module with the two thumbscrews located on the faceplate of the unit.