MotoSAT AutoMotion Dome T2 - Manual (Page 4)

4
Operating the T2 AutoMotion Dome
1- Plug in all necessary cable connections to the back of the T2 AUTOMOTION.
(See Figure Below)
A B C D
Connection Definition:
A. Out to Receiver (Receiver) - Used to connect the T2 AutoMotion to
the satellite receiver.
B. In from the Dish (Antenna) - Used to connect the dish to the T2
AutoMotion with the supplied single RG6 coax cable.
C. Not used. For testing purposes only
D. Power Cord to 115 VAC
Operation
2-
Turn on the T2 AutoMotion by pressing the power switch located on the front
panel.