Miele PW 6065 - Manual (Page 67)

Auto load control
The washer has an Auto load
control. The water levels and the
program running times are adjusted
to the load size. If the load size
automatic is turned off the program
will always run as if for a full load.
The machine comes factory set with
this option turned on.
Pre-wash water
The water type for the pre-wash can
be selected (except for the program
"Curtains"). The hot water intake will
be only accessible at a wash
temperature of 86°F (30°C) or
higher.
The machine comes factory set with the
water type "hot".
Main wash water
The water type for the main wash
can be selected (except for the
programs "Woollens", "Silk" and
"Curtains"). The hot water intake will
be only accessible at a wash
temperature of 86°F/30°C or higher.
The machine comes factory set with the
water type "hot".
If the washer is not connected to hot
water, the program running times will
be extended and vary from the
displayed remaining times.
If "Industrial water" is used, the
washer must be refitted accordingly.
Rinse water
The water type for the rinse in the
programs "Cottons Hygiene",
"Cottons Uni.", "Minimum iron", "Table
linen", "Kitchen linen", "Towelling"
and "Sluice" can be selected. The
hot water intake will be only
accessible at a wash temperature of
50°C or higher.
The machine comes factory set with the
water type "hot".
If "Industrial water" is used, the
washer must be refitted accordingly.
Settings - Supervisor level
67