Multiquip Mikasa Vibratory Walk-Behind Roller MDR-9D - Manual (Page 19)

MQ-MIKASA MDR-9D VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #0 (12/17/03) — PAGE 19
CHECKING HYDRAULIC SYSTEM
1. Check the oil tank level gauge (Figure 10). Oil level
should be at the middle indication of the gauge or
higher. Fill as required
2. Check the surroundings of the oil tank, hydraulic
pump and motor for oil leakage.
ALWAYS keep hands and fingers away from
pinch points. DO NOT allow anyone to reach
in on dangerous sections of the machine to
avoid any accidents.
DANGER
CHEKCING THE V-BELT
1. Check all bolts and screws and make sure all are
securely tightened.
2. Check V-belt for proper tension. The normal slack
should be approximately 1/8 inch (3 to 5 mm) when
the belts are forcibly depressed between the two
sheaves (Figure 11). Insufficient tension causes
weak vibration and machine damage.
CHECKING THE CLUTCH BOX OIL LEVEL
1. Check clutch box for any oil leakage.
2. Remove the level plug and check oil level (Figure 12).
3. Add oil if necessary.
Figure 10. Hydraulic System Oil Level Gauge
Figure 11. V-Belt Tension
Figure 13. Vibrator Oil Level Check
CHECKING THE VIBRATOR OIL LEVEL
1. Remove the red filler plug and the oil level inspection hole
plug from the vibrator case (Figure 13).
2. Fill with oil until oil overflows from inspection hole.
MDR-9D — INSPECTION
Figure 12. Clutch Box Oil Level Check