Metz SCA 3202-M User Manual

Page 34

Compare the results and then select the opti-
mal setting for your camera.

Manual flash mode M

Establish the necessary distance to the subject by
selecting a full or partial light output level taking
into account the lens aperture. Note the distance
indicated on the aperture calculator or the dis-
tance given on the LC display of the flash unit.

7. Troubleshooting hints

Should, for example the flash unit’s LC display in-
dicate meaningless information or should the flash
unit not function properly you can try to overcome
this problem as follows:

1a) Switch off the flash unit by its main switch.

1b) Remove its power sources.

1c) Switch on the flash unit for about 1 second

and then switch it off again.

1d) Reload the power sources.

or / and:

2a) Switch off the camera and the flash unit.

2b) Remove the SCA adapter from the flash unit

and then re-mount it again.

The flash unit should operate properly when it is
switched on again. Contact your local dealer
should this not be the case.

For up-to-date information please visit the Metz
Homepage: www.metz.de