Multiquip RIDE-ON TANDEM DRUM ROLLER AR13D - Manual (Page 31)

AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11) — PAGE 31
Forward/Reverse Relief Valves Drive Adjustment
The forward and reverse relief valves (Figure 35) are shim
type cartridge type and are located in the hydrostatic pump (not
on the manifold block) under plugs 1 and 2 . Plug 2 is located in
the same location as plug 1, except it is on the bottom side of the
pump. Relief valve 1 is
reverse and 2 is forward .
AR13D RIDE-ON ROLLER — MAINTENANCE
Figure 35. Adjusting Forward/Reverse
Relief Valves
Steering Relief Valve Pressure Adjustment
To adjust the relief valve steering pressure perform the following:
1. Insert an 8 mm allen wrench into steering relief port 4
(Figure 36) on the manifold block.
2. On the manifold, connect at 5,000 psi pressure gauge into
quick disconnect test
port 1 .
3. Start the engine and run at full throttle.
4. Turn the steering wheel to the left or right (maximum) and
hold. Read the steering relief pressure. The relief pressure
reading for the steering test port 1 will should be 700 psi.
5. If the steering relief pressure is not 700 psi, using the allen
wrench adjust the pressure at
port 4 until the pressure
gauge reads 500 psi.
Figure 36. Steering and Vibration Relief Valves
1. Clean the area around the cap.
2. Remove the cap.
3. Carefully remove the valve cartridge.
4. Using an allen wrench , remove the top nut (extreme care
must be taken not to loosen existing shims, spring, or valve)
Add or remove shims as required.
Adding shims increases
pressure; removing shims lowers pressure. One shim is
equal to approximately 50 psi. Shim P/N is 34538.
5. Install the top nut and install valve in the pump cavity using
extreme care not to bind.
6. Install the valve cap.
7. Re-test pressure, further adjustment may be needed if
pressure is not correct.
Axle Pumps supplied after 01/01/2003 DO NOT
have adjustable relief cartridges. The pressure
is fixed at 2,900 ± 145 psi. If the relief pressure is
not within normal range, the complete cartridge
must be replaced.
Vibration Relief Valve Pressure Adjustment
1. Insert an 8 mm allen wrench into steering relief port 5
(Figure 36) on the manifold block.
2. On the manifold block, insert a 5,000 psi pressure gauge
into quick disconnect test
port 1 .
3. Start the engine and run at full throttle.
4. To start the vibration, press the pushbutton switch
(vibration control) located on top of the travel lever. The
relief pressure should read 800 ~ 1,000 psi.
5. If the vibration relief pressure is not 800 ~ 1,000 psi using
the allen wrench adjust the pressure at
port 5 until the
pressure guage reads correctly.