Metrologic Instruments MS3580 - Manual (Page 38)

34
D EFAULT S ETTINGS - C OMMUNICATION P ARAMETERS
Many functions of the scanner can be "configured" - that is enabled or disabled.
The scanner is shipped from the factory configured to a set of default conditions.
The default parameter of the scanner has an asterisk ( * ) in the charts on the
following pages. If an asterisk is not in the default column then the default setting
is Off or Disabled. Every interface does not support every parameter. If the
interface supports a parameter listed in the charts on the following pages, a
check mark ( ) will appear.
P ARAMETER D EFAULT OCIA USB
RS232*
OR
RS232
TTL
L IGHT
P EN
IBM
46XX
KBW
L ASER
E MULATION
UPC/EAN *
Code 128 *
Code 93 *
Codabar *
Interleaved 2 of 5 (ITF) *
MOD 10 Check on ITF
Code 11
Code 39 *
Full ASCII Code 39
MOD 43 Check on Code 39
MSI-Plessey
MSI-Plessey
10/10 Check Digit
MSI-Plessey
MOD 10 Check Digit
Paraf Support
ITF Symbol Lengths Variable
Minimum Symbol Length 4
Symbol Length Lock None
RSS14 Enable
RSS14 ID “]e0” *
RSS14 App ID “01” *
RSS14 Check Digit *
RSS Expanded Enable