Maytag LSG7806AAE - Manual (Page 9)

8
Using the Controls – Dryer
Select Cycle
WRINKLE RELEASE will release wrinkles from items
that are clean and dry but slightly wrinkled. This cycle
is for clothes from a crowded closet or suitcase or from
sitting in the dryer too long after the end of the cycle. It
provides 10 minutes of heated tumbling and 5 minutes
of cool-down tumbling without heat. Press the START
button for the cycle to begin.
DAMP DRY is designed to “partially” dry items. It
provides approximately 20 minutes of heated tumbling
and 5 minutes of cool-down tumbling without heat.
Press the START button to begin tumbling.
TIME DRY may be selected for any load if the
IntelliDry sensor system is not desired. Set the control
to the desired number of minutes and choose the
appropriate drying temperature for the load. Then
press the START button.
AIR FLUFF provides tumbling without heat for
sensitive loads or items needing freshening. Examples
are: certain sweaters, shower curtains, camping gear,
pillows, etc. Set the control to the desired number of
minutes, up to 20 minutes, and press the START
button.
IntelliDry PERM’T PRESS with Press Care
automatically senses the moisture in the load and
shuts off when the selected dryness level is reached.
Permanent Press minimizes wrinkles of man-made
fabrics such as acrylic, nylon, polyester, or blends with
an extended cool-down by tumbling the load in
unheated air at the end of the cycle. Simply set the
control to the desired dryness level (more dry – less
dry) and press the START button. The middle ▲ is the
initial preferred setting for the majority of loads.
IntelliDry REGULAR FABRICS automatically senses
the moisture in the load and shuts off when the
selected dryness level is reached. This cycle is
designed for loads such as towels, underwear, t-shirts,
jeans, etc. Set the control to the desired dryness level
(more dry – less dry) and press the START button. The
middle ▲ is the initial preferred setting for the majority
of loads.
STEP 1