Configuring the sources, Configuring sources, Configuring – Meridian America 562V.2 User Manual
Page 35: Cdcd
Configuring the multimedia controller without a computer
30
To configure a source
●
Turn off the multimedia controller, using the power switch on
the back panel.
●
Turn on the power again while holding down the Display key
on the front panel until the display shows Conf.
●
Press Source until the left-hand pair of characters identifies
the source you want to configure.
For example, to configure the CD
source the display initially shows:
CDCD
●
Press Copy (front panel), or
>
>
>
>
> and <
<
<
<
< (remote), to step
between options.
The right-hand pair of characters shows the current value of the
option.
●
Press
A or V to change the value of the option.
When you have finished programming sources:
●
Switch off at the back panel, and then switch on again to
restore normal operation.
Configuring the sources
When the multimedia controller is set to one of the standard
settings the 12 source selection keys on the remote select the
standard labels and inputs, as shown in the table on page 29.
If the configuration you want is not catered for by one of the
standard settings, you can configure each source individually.
The 562V Multimedia Controller provides 12 sources
corresponding to the 12 source selection keys on the remote:
CD, Radio, LP, TV, Tape1, Tape2, CDR, Cable, DVD, VCR1,
VCR2, and LD.
For each source you can configure:
❍ The label used for it on the front panel display, from a range of
alternative labels.
❍ The audio input it selects.
❍ The comms type and address, to identify other Meridian 500
Series equipment.
❍ The composite video and S-video inputs it selects.