Mustang Survival MD3025NV - Manual (Page 7)

Information: The carbon dioxide used to inflate PFDs will
slowly permeate through the fabric cell over time. A slight
reduction of pressure will be observed after several hours
of inflation. Topping up by oral inflation may be required
in the event of very prolonged immersion.
Rearming Your PFD After Manual Inflation
1) Unscrew and inspect the CO2 cylinder. If used or damaged, discard
the CO2 cylinder (Fig 1c).
2) Check the manual lever to ensure it is in the up and ready position
with the green indicator pin properly installed. If the green indicator
pin is missing or damaged, replace it (Fig. 4a).
3) Install an unused CO2 cylinder by screwing it into the top of the
inflator and hand-tighten. Do not
over-tighten, as this can damage
the internal gasket.
4) Refold the PFD in accordance with
the repacking instructions in the
Owner’s Manual.
Your PFD is now ready for use.
p 6
Fig. 3a
Fig. 4a
Fig. 3b