beautypg.com

Preparing for use, Fitting instructions, Unpacking and inspection – Maxon Telecom UM-SL55 User Manual

Page 9: Attaching and removing the antenna, Attaching and removing the batterypack, Attaching and removing the belt clip, English 7

background image

PREPARING FOR USE

UNPACKING AND INSPECTION

Unpack the radio and check that you have received the

following items:

• SL55+ handportable radio

• Battery pack

• Antenna

• Belt clip

If any of these items are missing, please contact your dealer.

FITTING INSTRUCTIONS

ATTACHING AND REMOVING THE ANTENNA

A high quality matched antenna is supplied with the SL55+

radio. Install the antenna by turning clockwise into the

antenna receptacle on the top of the radio, until it is firmly

seated. Do not over tighten. To remove the antenna,

reverse the above procedure.

Never operate the radio without the antenna fitted.

Always use Maxon approved antenna.

ATTACHING AND REMOVING THE BATTERYPACK

Please refer to the picture on the inside rear cover.

Hold the radio face down in your hand. To attach the

battery pack, pick up the pack by the sides and hold it so

that the latch is facing upward. Place the bottom of the

battery pack into the base of the radio at approximately a 45º

angle. Gently push battery into the radio back until the

battery latch snaps firmly into place.

Remove the battery pack by holding the radio face down in

your hand. Press down and hold the battery latch. Gently

pull the battery out and away from the radio.

ATTACHING AND REMOVING THE BELT CLIP

The belt clip attaches to the radio’s battery pack. To attach

the belt clip, hold the clip and slide it into the recessed area

at the top of the pack. A click will verify the clip is securely

positioned. To remove the clip, press and hold the release

tab toward the clip while gently pulling the belt clip assembly

off the radio.

ENGLISH

7