Makita DCS 6800I - Manual (Page 21)

21
F
STOP
G
3
4
D
STOP
E
1
2
AVOID SKIN AND EYE CONTACT
Mineral oil products degrease your skin. If your skin comes in
contact with these substances repeatedly and for an extended
period of time, it will desiccate. Various skin deseases may
result. In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil. If oil comes into your
eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!
Refuelling
Lubricating the chain
During operation there must always be sufficient chain oil in
the chain-oil tank to provide good chain lubrication. One filling
is sufficient for about one half-hour of continuous operation.
fuel/oil mixture chain oil
Adjusting the chain lubrication
The engine must be switched off.
You can adjust the oil pump feed rate with the adjusting screw
(F/1). The adjusting screw is located in the housing underneath
the sprocket guard (F/2). It is accessible from below.
The oil pump comes factory-set to a medium feed rate.
Note: To set from minimum to maximum oil supply, turn the
adjusting screw (F/1 with adjustment markings) a 1/4-turn.
To ensure troublefree operation of the oil pump the oil guide
groove at the crank case (G/3) and the oil inlet bore in the guide
bar (G/4) must be cleaned regularly.
To change the feed quantity use the universal wrench and
adjust the adjusting screw (F/1) in the following way:
- Turn to the right to reduce the feed rate.
- Turn to the left to increase the feed rate.
Note: After the saw has been turned off it is normal for
residual chain oil to drip from the oil feed system, the guide
bar and the chain for a time. This does not constitute a defect!
Place the saw on a suitable surface.
FOLLOW THE SAFETY PRECAUTIONS!
Be careful and cautious when handling fuels.
The engine must be switched off!
- Thoroughly clean the area around the caps, to prevent dirt
from getting into the fuel or oil tank.
- Unscrew the cap and fill the tank with fuel (fuel/oil mixture)
or chain oil as the case may be. Fill up to the bottom edge
of the filler neck. Be careful not to spill fuel or chain oil!
- Tightly screw on the cap.
Clean screw cap and tank after refuelling.