Micronics 60/66MHz - Manual (Page 15)

2 - 5
Jumper Settings
Table 2-8 lists the jumper settings to select a DMA channel for the parallel
port.
Jumper Function Setting
W6 DMA Channel 1
DMA Channel 3
DMA not used (default) 1-2
2-3
open
W7 DMA Channel 1
DMA Channel 3
DMA not used (default) 1-2
2-3
open
Table 2-8 Parallel Port DMA Channel Selection
Table 2-9 lists the jumper settings for programming the Flash ROM.
Jumper Function Setting
W22 Flash ROM programming disabled (default)
Flash ROM programming enabled open
close
Table 2-9 Flash ROM Selection
Table 2-10 lists the jumper settings to reset the CMOS to its default settings.
Resetting the CMOS will clear all settings.
Jumper Function Setting
W24 Clear CMOS
Normal (default) close
open
Table 2-10 BIOS Reset