Morphy Richards 27005 - Manual (Page 8)

RADIO OPERATION
•
Switch on and off with the ON/OFF switch.
•
Adjust the volume with the VOLUME control.
•
The tone can be adjusted with the TONE control.
Aerials
-The telescopic aerial is intended for receiving FM (VHF) stations.
-The aerial should be fully extended and rotated until best results are
achieved.
For receiving MW and LW stations there is a ferrite rod aerial inside the radio.
The best position for receiving a station will be found by rotating the radio.
Wavebands
-Select the waveband with the switch FM/MW/LW. The selected waveband
is shown on the display.
On FM (VHF) the frequency is shown in MHz, and on MW (mediumwave)
and LW (longwave) in kHz
Sensitivity switch (LOCAL/DIST)
-Normally this switch should be set to the DIST position - remote stations.
-If the signal received is too strong (distortions), set the switch to LOCAL +
nearby stations.
The switch functions only on FM reception.
Last station memory function
The station to which the radio was tuned prior to switch off will automatically
be selected on switch on.
When changing the waveband, the last station to which the radio was tuned
in each waveband will also be stored in the memory.
Tuning to stations
•
Select the waveband with the BAND switch FM/MW/LW.
•
Start the station search with the + button (in the direction of higher
frequencies) or with the - button (in the direction of lower frequencies).
-Pressing briefly + tuning in steps
-Pressing longer + tuning automatically
-The tuning steps are 50kHz for FM, 9 kHz for MW and 1kHz for LW.
7