Motorola DCT700 - Manual (Page 17)

10
USING THE REMOTE CONTROL
+
+
Installing Batteries
Before you can use the remote control, you must install two AA
(1.5-volt) alkaline batteries (provided with your Motorola universal
remote control):
1
Slide open the battery door on the back of the remote control.
2
Insert the batteries in the direction indicated on the inside of the
battery compartment.
Batteries installed incorrectly can cause battery leakage and
corrosion that will damage the remote control.
3
Slide the battery door closed until it snaps into place.
Point the remote control at the DCT700, and then press POWER . If the
DCT700 does not turn on, check the orientation of the batteries or
replace with new batteries.
Your remote control may be different from the Motorola DRC450
Universal Remote Control illustrated here. Refer to the remote control
User Guide for details on installing batteries.