Musical Fidelity X-RAY V3 - Manual (Page 14)

SPECIAL FEATURES
If you wish to check the selection before
playing back your program, the
CHECK
button can be pressed to step through each
program entry in turn.
If during this check sequence the PLAY
button is pressed, the remaining part of your
programmed selection will play to the end
of the sequence.
Otherwise, to play all the programmed
tracks from the beginning of the sequence,
press
PLAY/PAUSE, or PLAY on the
remote control.
The >>| may be pressed to jump to the
next track in the programmed sequence, or
the
|<< button to obtain the previous track
in the sequence.
When all programmed tracks have been
played, the CD player stops. The same
track selection can then be played again by
pressing the
PLAY/PAUSE button on the
front panel, or PLAY on the remote control.
To repeat a programmed sequence continu-
ally, press
REPEAT whilst playing the pro-
gram.
To cancel this mode, press PROGRAM.
Note: The program contents will be cleared
if you switch off the power, or open the disc
drawer and load another disc. If, however,
the same disc is loaded again with the
power still switched on, the program
sequence is retained in the memory.
DISPLAY
X-Ray V 3 display brightness can be con-
trolled in three levels by pressing the DIS-
PLAY button on the remote control.
The original setting is maximum brightness,
but by pressing the
DISPLAY button once,
brightness is reduced, and a further press
turns the display off.
However, when the display is off, pressing
any button returns the brightness to normal
(maximum).
X-RAY V 3 Instructions for Use Page 14 of 16 Issue 2: March 2004