Connecting the symbol miniscan – Motorola SYMBOL MS120XWA User Manual
Page 6
6
Symbol MiniScan Family of Scanners
-
Low Profile DB9 USB Cable (18 in. straight); without
trigger jack; without beeper,
p/n 25-58926-02R.
•
Other:
-
Fixed mount stand,
p/n 20-60136-01R
-
Simple Serial Interface Software Developer's Kit
(SSISDK). To download an SSISDK, go to:
Connecting the Symbol MiniScan
The Symbol MiniScan can be triggered either by a
software trigger command, or by an external switch. If the
Symbol MiniScan scanner came without a host cable, or if
you are constructing an external triggering switch, consult
the Symbol MiniScan Integration Guide.
To connect the Symbol MiniScan:
1.
Plug the 9-pin D-connector with the end marked “TO
SCANNER” into the Symbol MiniScan scanner.
2.
If using an external switch and applicable host cable,
plug the trigger cable into the female stereo connector
on the flying lead of the 9-pin D-connector.
3.
Plug the output cable from the power supply into the
receptacle on the end of the connector near the host
end of the cable. (USB and Synapse cables do not
require a power supply.)
4.
Plug the host side connector into the appropriate port
on your host terminal.
5.
Check all connections to ensure they are secure.