Philips Magnavox 19MF338B - Manual (Page 9)

EN-8
ENGLISH
FRANÇAISE
ESP
AÑOL
Install the remote control 4.3 batteries
Open the battery cover on the back of the 1.
remote control.
Insert the 2 batteries supplied. Make sure the
2.
+ and - ends of the batteries line up correctly.
(inside of case is marked).
Close the cover.
3.
Connect the antenna or 4.4 cable
This section describes how to connect your TV to an
antenna, cable, Direct Broadcast Satellite, and to a
cable receiver box.
CABLE
SATELLITE
Cable Receiver Box
OR OR
ANTENNA SATELLITE CABLE
OR
Cable
Receiver Box
OR
CABLE
Connect to an antenna
Any DTV programs that are broadcast in your
area can be received for free through an antenna
connection.
Contact your local content provider or your local
electronics retailer if you are unsure about what
HDTV programs are available in your area.
Broadcasters are transitioning from analog to digital
TV. This means that a given broadcaster can have
channels available either in analog or in digital, or
both analog and digital at the same time.
The TV has stereo sound if the broadcasting channel
makes it available.
Firmly pull the stand from the bottom of the TV. 3.
Place both the stand and bolts in a secure
location for future reinstallation.
Step 3 Connect cables
Connect the antenna cable, AC power cord and all
other devices to the back of the TV as described in
the following sections and in Section 7 Connect devices.
Step 4 Secure the VESA-compatible wall
bracket to the TV
WARNING B
Only use the specified bolts (M4) to secure
the VESA-compatible wall bracket to your
TV. The specified bolts are designed to
match the weight of your TV.
Note D
Depending on your VESA-compatible wall
bracket, you may need to separate the mounting
plate from the wall bracket for easier installation.
Refer to your VESA-compatible wall bracket
documentation for instructions.
100x100 mm