Metrik Mobile Electronics MIN-T66 - Manual (Page 3)

2
CAUTION
Safety precautions
Be sure the unit is connected to a 12V
DC power with a Negative Ground.
Do not install the unit in places where
it is exposed to direct sunlight,high heat
or humidity,water splash or dust.
To change fuse,please use the same
one in specification and capacity.
When changing fuse,please do it
after pulling down power wires to avoid
short circuit.
Do not place anything on the display
when then panel is tilted.
If the unit seems not work properly press
the reset button to reset the memory of the
unit.
Do not operate when driving.
Be sure to store the liquid crystal panel
inside the main unit when parking the car
outdoors for long time.
To prevent electric,etc,Please do not
let
If you smell or see smoke,turn off the
power immediately and consult our dealer.
Be careful not to drop or shock the unit
strongly.
Do not touch the liquid crystal to avoid the
life hurt.If the clothes is stained with it,Please
clean it immediately by soap.
the metal goods(silver,coin,tools..)fall into
the installation.
In extremely cold weather, the display
movement may slow down and the display
may darken, but this is not a malfunction.
Then display will work normally when the
temperature increases.
To prevent damage to the machine,
take the following precautions:
WARNING
To prevent injury or fire,Please
take the precautions: following
SRC ADJ OPEN/CLOSE
MUT
APS
BAND
MENU
RESET
RESET
ON/OFF