McCulloch 966564101 - Manual (Page 38)

1
2
1
3
mAINTENANCE
38
WARNING!
The machine must be standing
absolutely still when the park brake
is engaged.
Visually check that no damage is found on the lever,
linages, or switch belonging to the parking brake.
Perform a stand still test and check that there is a
braking action.
To adjust the parking brake, contact the McCulloch
service workshop.
Parking Brake
WARNING!
Faulty adjustment can cause an
accident.
Deck Belt
Check every 100 hours of operation. Check for severe
cracking and large nicks.
NOTE: The belt will show some small cracks in
normal operation.
The belts are not adjustable. Replace belts if they
begin to slip from wear.
Deck Belt Removal
Park on a level surface. Apply parking brake. 1.
Lower the deck into the lowest cutting position. 2.
Remove bolts from belt shields and remove 3.
shields.
Remove any dirt or grass that may have
4.
accumulated around the cutter housings and
entire deck surface.
Loosen the nut securing the belt guide. Note the
5.
position of the belt guide for reinstallation.
Carefully roll the belt over the top of the cutter
6.
housing pulleys and remove belt from the deck.
8058-080-1
Released parking brake
8058-107
Belt shields 1.
Belt guide 2.
Idler arm 3.
Removing the deck belt