Magnadyne Universal Watertight Marine Radio Controller with Speed Indicators MRC-2U - Manual (Page 7)

Manufacturer Group Sub-Group Radio
1 Alpine
2 JVC
3 Pioneer
1 MobileVision and MB Quart
2 Kenwood
1 Sony
Flashes the Number
of Times the Switch is
Pressed, Confirming
Group Number
7
Step 1
Turn on the power to the receiver’s
housing. Press and hold the button on the receiver for 3 seconds. The LED
on the receiver will flash 2 times and then turn off. Release the
switch. You are now in “Automatic Code Learning” mode.
Step 2
Flashes 2 Times
Learning the Radio’s Remote Code
Step 3
Press the switch on/off the number of times accord-
ing to the radio manufacturer’s Group number listed
in the Manufacturer’s Code Look-Up Table.
The LED will flash the number of times confirming
the manufacturer’s group selected.
Press the switch on/off the number of times accord-
ing to the radio manufacturer’s Sub-Group number
listed in the Manufacturer’s Code Look-Up Table.
The LED will flash the number of times confirming
the manufacturer’s sub-group selected.
Flashes the Number
of Times the Switch is
Pressed, Confirming
Sub-Group Number
Step 4
Manufacturer’s Code Look-Up Table
1
2
3
Alpine,
JVC,
Pioneer
MobileVision,
MB Quart,
Kenwood
Sony
3 Seconds
Automatic Code Learning
First, see if your radio is in the Manufacturer’s Code Look-Up Table below. If your radio is listed in the table
go to “Automatic Code Learning”. If you can not find your radio in the list go to “Manual Code Learning”.
Note: This receiver will only retain the one Radio Remote Code.