Magnadyne Universal Watertight Marine Radio Controller with Speed Indicators MRC-2U User Manual

Page 10

Step 1

Turn on the power to the receiver’s
housing.

Press and hold the button on the receiver until the LED turns
on solid.

Step 2

Solid LED

Learning an Additional Aquavibe Marine Remote Controller Code

Hold

While still pressing the button on the receiver, press and release the SRC button on the remote until the
LED on the receiver flashes 2 times, indicating the code is learned.

Flashes 2 Times

Keep Hold

Step 3

Release the receiver’s button and the LED will turn off.
Repeat Steps 2-4 to program additional remotes.
Note: Up to 4 remotes can be programmed.

Step 4

LED Off

Release Button

The Aquavibe Marine Remote Controller is already pre-programmed to the receiver. No programming is
necessary. If you want to program additional Aquavibe Marine Remote Controllers follow the instructions
below.

Note: This receiver will only retain the 4 Marine Remote Controller codes. If the receiver’s memory is
exceeded, the receiver will start deleting transmitters codes from memory in chronological order.