Miele H4200 - Manual (Page 57)

All electrical work should be
undertaken by a suitably qualified
and competent person in strict
accordance with national and local
safety regulations (BS 7671 in the
UK).
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
Ensure power is not supplied to the
appliance while installation or repair
work is being carried out.
The voltage, rated load and fusing are
given on the data plate, visible below
the oven interior, with the oven door
open. Ensure that these match the
household mains supply. Please quote
these data, and the model and serial
number when contacting the Miele Ser-
vice dept.
Connection of this appliance should be
made either via a fused connection unit
(rated load under 3000 W), or via a
suitable isolator (rated load over 3000
W), which complies with national and
local safety regulations, and the on/off
switch should be easily accessible after
the appliance has been built in.
If the socket is not accessible after
installation (depending on country) an
additional means of disconnection must
be provided for all poles.
For extra safety it is advisable to install
a residual current device with a trip
current of 30 mA (in accordance with
DIN VDE 0664, VDE 0100 Section 739).
When switched off there must be an
all-pole contact gap of 3 mm in the
isolator switch (including switch, fuses
and relays acc. to EN 60 335).
Important U.K.
This appliance is supplied with a 3-core
cable for connection to a single phase
230-240 V 50 Hz supply.
The wires are coloured in accordance
with the following code:
Green/yellow = earth
Blue = neutral
Brown = live
In other countries check these details
with your supplier.
WARNING
THIS APPLIANCE MUST BE
EARTHED
Electrical connection UK, IRL, ZA
57