beautypg.com

Before use, Standby – Marantz CR401 User Manual

Page 6

background image

2

ENGLISH

BEFORE USE

This section must be read before any connection is
made to the mains supply.

7 Equipment mains working

setting

Your Marantz product has been prepared to
comply with the household power and safety
requirements that exist in your area.
CR401 can be powered by 230V AC only.

7 Copyright

Recording and playback of any material may
require consent. For further information refer to the
following:

– Copyright Act 1956
– Dramatic and Musical Performers Act 1958
– Performers Protection Acts 1963 and 1972
– Any subsequent statutory enactments and

orders

7 Do not locate in the following

places

To ensure long-lasting use, do not locate the
CR401 where:

• Exposed to direct sunlight.

• Near to sources of heat such as heaters.

• Highly humid or poorly ventilated.

• Dusty.

• Subjected to mechanical vibrations.

• On wobbly, inclined or otherwise unstable

surfaces

• Radiated heat is blocked such as in cramped

audio racks.

To ensure proper heat radiation, ensure the below
clearance from walls and other equipment.

Noise or disturbance of the picture may be
generated if this unit or any other electronic
equipment using microprocessors is used near a
tuner or TV.
If this happens, take the following steps:

• Install this unit as far as possible from the tuner

or TV.

• Set the antenna wires from the tuner or TV away

from this unit’s mains cord and input/output
connection cords.

• Noise or disturbance tends to occur particularly

when using indoor antennas or 300

/ohms

feeder wires. We recommend using outdoor
antennas and 75

/ohms coaxial cables.

Note

For heat dispersal, do not install this equipment
in a confined space such as a book case or
similar unit.

7 Do Not Touch Hot Spots During

and Immediately After Use

During and immediately after use, the CR401 is hot
in areas other than the controls and rear panel
connection jacks. Do not touch hot spots and
especially the top panel. Contact with hot areas
can cause burns.

7 Accessories

• Remote control unit (RC601CR) x 1

• Size “AAA” batteries x 2

• AM loop antenna x 1

• FM indoor antenna x 1

• User Guide x 1

• Registration Card x 1

STANDBY

STANDBY

PHONES

PHONES

POWER ON / STANDBY

POWER ON / STANDBY

CD RECEIVER CR401

CD RECEIVER CR401

PUSH TO ENTER

PUSH TO ENTER

VOLUME

VOLUME

TREBLE

TREBLE

BASS

BASS

INPUT

INPUT

MENU

MENU

DIRECT

DIRECT

0.2 m
or more

0.2 m

or more

0.2 m or
more

0.2 m

or more

7 ABOUT DISCS

Playable discs

* Finalize is the process to make a CD-R/CD-RW

playable for players (not recorders)

* Some discs may not be able to be played

depending on condition of the discs and
recording software.

Structure of audio CD

Audio CDs contain music tracks only.
You can play them in conventional style through a
stereo system, using the keys on the remote
control and/or front panel.

About playing copy-controlled CDs

Some copy-controlled CDs may not conform to
official CD standards. They are special discs and
may not play on the CR401.

Discs made on personal computers

Discs made on personal computers, including
those of a compatible format, may not work
properly in the CR401 because of incorrect
settings in the disc burning software. Check the
manual supplied with your disc burning software
for additional compatibility information.

Audio CD (CD-DA)

CD-R/CD-RW

Finalized CD-R and CD-RW discs
recorded in the CD-DA format,
MP3 format can be played with
the unit.