MITSUBISHI ELECTRIC MLM400 - Manual (Page 6)

4
You can attach mounting accessories to the LCD monitor in one of the
following two ways:
1. In the upright position
Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surrounding objects
as shown in the diagram to the right.
Attaching LCD Options
2. Lay the screen face down
To avoid damaging the screen face, place the protective sheet on the
table to lay the LCD on. The protective sheet was wrapped around the
LCD in the original packaging.
This device cannot be used or installed without the Tabletop Stand or
other mounting accessory. For proper installation it is strongly recom-
mended to use a trained, Mitsubishi authorized service person. Fail-
ure to follow Mitsubishi standard mounting procedures could result in
damage to the equipment or injury to the user or installer. Product
warranty does not cover damage caused by improper installation.
Failure to follow these recommendations could result in voiding your
warranty.
When using mounting accessories, other than Mitsubishi compliant
and approved, they must be VESA-compatible mounting method.
Mitsubishi strongly recommends using screws M4 size and 8mm in
length. If using screws longer than 8mm, check the depth of the
hole.
(Recommended Fastern Force: 150 ~ 170N•cm)
Mitsubishi recommends using mounting interface that comply with
UL1678 standard in North America.
To avoid falling down
Fasten the LCD monitor to a wall using a cord or chain which is suffi-
cient to support the weight of the LCD monitor (approx. 31.5kg).
Before moving the LCD monitor, the cord or chain should be removed.
Screw Holes
Clamper
Cord or Chain
Screw
MLM400
* Ambient temperature should be less than 40 deg C
*
Table
Protective Sheet
Tabletop Stand
EXIT MUTE INPUT
100 100
100
100
100
MLM300