Makita LS1011N User Manual
Page 25
25
1. Miter angle
Push the carriage toward the guide fence and tighten the
clamp screw on the turn base to secure the carriage.
Loosen the clamp screw on the guide fence which
secures the turn base. Turn the turn base so that the
pointer points to 0° on the miter scale. Then turn the turn
base slightly clockwise and counterclockwise to seat the
turn base in the 0° miter notch. (Leave as it is if the
pointer does not point to 0°.) Loosen the hex bolts secur-
ing the guide fence using the socket wrench.
Lower the handle fully and lock it in the lowered position
by pushing in the stopper pin. Square the side of the
blade with the face of the guide fence using a triangular
rule, try-square, etc. Then securely tighten the hex bolts
on the guide fence in the order from the right side.
Make sure that the pointer points to 0° on the miter
scale. If the pointer does not point to 0°, loosen the
screw which secures the pointer and adjust the pointer
so that it will point to 0°.
2. Bevel angle
(1) 0° bevel angle
Push the carriage toward the guide fence and
tighten the clamp screw on the turn base to secure
the carriage. Lower the handle fully and lock it in the
lowered position by pushing in the stopper pin.
Loosen the lever at the rear of the tool.
1. Guide fence
2. Hex bolts
2
1
002184
1. Guide fence
2. Triangular rule
2
1
002185
1. Screw
2. Miter scale
3. Pointer
2
3
1
002186
002187