Maytag Stacked Laundry - Manual (Page 13)

11
Won’t Fill
Won’t Spin
or Drain
Won’t Agitate
Check these points if your clothes washer...
Before You Call
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Close lid and pull control knob out to start the washer. For your safety,
washer will not fill unless the lid is closed.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Close lid and pull control knob out to start the washer. For your safety,
washer will not agitate or spin unless the lid is closed.
• Unevenly distributed load. Redistribute the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable for load size.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a drain restriction,
call for service.
• Close lid and pull control knob out to start the washer. For your safety, wash-
er will not agitate or spin unless the lid is closed.
• Suds lock – caused by too much suds. Rewash without detergent. Use cor-
rect amount of a low-sudsing detergent.
For problem laundry solutions (i.e. fabric damage, residue, tangling) and special laundry care proce-
dures, see the enclosed Laundering Tips pamphlet.
(Continued on next page.)