Multiquip Plaster and Mortar Mixer WM-90S - Manual (Page 17)

WM-90 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/10/04) — PAGE 17
WM-90 PLASTER/MORTAR MIXER — ENGINE COMPONENTS
Figure 6. Engine Controls and Components
Initial Servicing
The engine (Figure 6) must be checked for proper lubrication
and filled with fuel prior to operation. Refer to the
manufacturers engine manual for instructions & details of
operation and servicing.
1. Fuel Filler Cap – Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely. DO NOT over fill.
5. Fuel Valve Lever – OPEN to let fuel flow, CLOSE to
stop the flow of fuel.
6. Choke Lever – Used in the starting of a cold engine, or
in cold weather conditions. The choke enriches the fuel
mixture.
7. Air Cleaner – Prevents dirt and other debris from
entering the fuel system. Remove wing-nut on top of air
filter cannister to gain access to filter element.
Operating the engine without an air
filter, with a damaged air filter, or a
filter in need of replacement will
allow dirt to enter the engine,
causing rapid engine wear.
Adding fuel to the tank should be done only when the
engine is stopped and has had an opportunity to cool
down. In the event of a fuel spill,
DO NOT attempt to start the engine until
the fuel residue has been completely
wiped up, and the area surrounding the
engine is dry.
DANGER DANGER DANGER DANGER DANGER
2. Throttle Lever – Used to adjust engine RPM speed
(lever advanced forward
SLOW, lever back toward
operator FAST).
3. Engine ON/OFF Switch – ON position permits engine
starting, OFF position stops engine operations.
4. Recoil Starter (pull rope) – Manual-starting method.
Pull the starter grip until resistance is felt, then pull
briskly and smoothly.
8. Spark Plug – Provides spark to the ignition system.
Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch)
Clean spark plug once a week.
9. Muffler – Used to reduce noise and emissions.
10. Fuel Tank – Holds unleaded gasoline. For additional
information refer to engine owner's manual.
NOTE
WARNING WARNING WARNING WARNING WARNING
Engine components can generate
extreme heat. To prevent burns, DO
NOT touch these areas while the engine
is running or immediately after
operating. NEVER operate the engine
with the muffler removed.
Explosive
Fuel Hazard
Burn Hazard