Moyer Diebel 301HT M2 - Manual (Page 21)

13
Troubleshooting
Troubleshooting
Condition Cause Solution
Insufficient pumped Clogged pump intake screen . . . . . Clean
spray pressure Clogged spray pipe . . . . . . . . . . . . Clean
Scrap screen full . . . . . . . . . . . . . . . Must be kept clean and in place
Low water level in tank . . . . . . . . . . Check drain and overflow tube
Defective pump seal . . . . . . . . . . . . Contact service agent
Insufficient final rinse or Clogged rinse nozzle and/or arm . . Clean with paper clip/delime
no final rinse Clogged strainer . . . . . . . . . . . . . . . Clean or replace
Low final rinse Low incoming water . . . . . . . . . . . Check the booster be sure the
temperature thermostat is set to maintain
180°F/82°C temperature.
Check fill valve operation.
Defective thermometer . . . . . . . . . . Check for proper setting or replace
Poor washing results Detergent dispenser not
operating properly . . . . . . . . . . . . . Contact detergent supplier
Insufficient detergents . . . . . . . . . . Contact detergent supplier
Food Soil concentration too
high in wash tank . . . . . . . . . . . . . . Drain tank, clean and refill every
2 hours of operation or after each
meal period.
Wash water temperature too low . . See condition “Wash Tank
Water Temperature” above
Wash arm clogged . . . . . . . . . . . . . Clean
Wash arm not rotating . . . . . . . . . . Clean arm. Check bearing,
replace if necessary.
Improperly scrapped dishes . . . . . . Check scrapping procedures
Ware improperly placed in rack . . . Use proper racks. Do not overload racks
Improperly cleaned equipment . . . Unclog wash sprays and rinse nozzles
to maintain proper pressure and flow
conditions. Overflows must be open.
Keep wash water as clean as possible.
Heating element has
soil/lime buildup . . . . . . . . . . . . . . Clean and/or de-lime.
Detergent pick up tube
in incorrect container . . . . . . . . . . Place RED pick up tube in
detergent container