Memorex iFlipTM - Manual (Page 8)

7
INSERTING AN iPod
Press the Dock Release button.
Locate the correct holder to use as
shown on page 10. Insert the
holder onto the dock (as shown)
and slip the side tabs into place.
IMPORTANT NOTE:
If you are using the holder marked
“A compatible with any iPod with
dock connector”, please insert the
iPod universal dock (not included)
corresponding to your iPod model
onto the dock. Then, insert the
holder followed by the iPod.
1
Once you connect the iPod, it will
start charging the battery until it is
full. (The iPod can charge only
when the Mi8000 is connected with
the AC adapter.) When the iPod is
connected to the Mi8000, it will be
in Charging mode until the battery
is full. Please see the next page for
instructions on using an iPod with
this unit.
3
Insert the iPod onto the holder.
Gently push down so the
connector on the iPod slides onto
the connector on the Mi8000.
Press the edge area of the holder
down gently (as shown) until it
clicks into place.
NOTES:
• To remove, press the Dock
Release button again. Then,
remove the iPod first, followed
by the holder.
• Do not press the holder by
pushing the iPod.
2