Mr. Coffee EXP1 or EXP3 - Manual (Page 11)

Cleaning Light
Mineral deposits in your water affect the performance of your
coffeemaker. A build up of deposits will slow the brewing cycle
and cause your coffee to become bitter.
When the Cleaning Light is on, the machine should be cleaned,
immediately. The light will remain on, in between brewing cycles,
until your coffeemaker is cleaned.
Note: jn some instances, mineral build up may flake off and clog
the inside of your coffeemaker before the cleaning light turns on.
You will know when you begin to notice an increase in steaming.
Clean your coffeemaker, immediately.
How To Use The Electronic Cleaning Cycle
For convenience and efficiency, The Expert’s built-in cleaning
cycle is designed to clean your machine slowly and thoroughly
while unattended and will shut itself off automatically when the
cleaning cycle has completed.
To clean your coffeemaker, use MR. COFFEE CLEANER or
undiluted vinegar. For best results, use MR. COFFEE CLEANER.
It cleans better than vinegar and has no unpleasant odor.
Using Mr. Coffee Cleaner:
(Read Caution Statement on Side Panel of Mr. Coffee Cleaner
Box Before Use)
1. Fill the decanter with warm water to the 5 cup mark.
2. Empty contents of one packet of MR. COFFEE CLEANER into
the decanter and stir until the cleaner is completely dissolved.
This will make a clear blue solution.
3. Pour the blue solution into the coffeemaker.
4. Place a Mr. Coffee filter in the brew funnel and slide funnel
back into place. Place empty decanter with lid on the warming
plate.
5. Set the “Warmer Temperature” dial to
CLEAN by rotating the dial to the right until
it stops, see figure #3, and depress the
SELECT button until the”Warmer On” light
glows.
Figure 3
6. The cleaning solution is pumped very
slowly through the machine to thoroughly
clean out all mineral deposit build-up.
7. When all of the 5 cups of blue solution has been pumped
back out turn the coffeemaker off by depressing the SELECT
button until all operating lights are off. If left unattended, The
Expert will shut itself off automatically in approximately 1-
2 hours.
1 0