beautypg.com

Automatic pause ‘n serve, Setting the clock and timer – Mr. Coffee EXP1 or EXP3 User Manual

Page 10

background image

4 .

5 .

the decanter is not properly placed on the warmer plate,

-

or, in about five hours, whichever comes first.

Note: The Expert may not always shut off when the decanter

Is remo

m the warmer plate if the warmer temperature

setting

low. If this situation occurs, simply turn the

temperature ‘up slightly by rotating the dial clockwise.

Automatic Pause ‘N Serve

For your convenience, our Automatic Pause ‘n Serve feature allows

you up to 30 SECONDS to sneak a cup while the coffee is still

brewing. But don’t delay, if the decanter is removed for more than
30 seconds, the brew funnel may overflow.

Setting The Clock And Timer

To Set the Clock...

1. Plug the power cord into a standard electrical

outlet.

2 .

Alternately press and hold the HOUR and

MINUTE buttons until you reach the current

time. AM and PM indicators are provided in
the display, for your convenience.

Figure 2

To Pre-Set the Brewing Time...

Simply press and hold the BREW button while setting the brew

time with the HOUR and MINUTE buttons. The display will indicate
the AM or PM BREW time you have selected. See Figure #2.
At any time you can check the pre-set brew time by simply
depressing the BREW button. The clock display will show the pre-
set AM or PM BREW time you have selected.

To Automatically

Brew at Pre-Set Time...

1. Follow steps #l through #5 in the section “How to Brew Coffee”.

2. Turn the coffeemaker to “Auto Start” by depressing the SELECT

button until the “Auto Start” light is on. The coffeemaker is
now set to automatically brew coffee at the preset time.

3. At the desired brewing time, the “Auto Start” light will turn

off and the “Brewer On” light will glow, indicating that the
coffeemaker is brewing.

,

4. The brewing cycle is completed when the “Brewer On” light

goes off and the “Warmer On” light is glowing.

5. The Expert will NOT automatically come on again the next day.

To reset “Auto Start”, repeat steps #l and #2 above.

Power loss back-up...

If power supply is cut-off, the timer will continue to operate for
up to 10 minutes. No need to reset the clock after a brief power

outage.

9