Miele S 6000 - Manual (Page 10)

The illustrations referred to in the text
are shown on the fold-out pages at the
end of these operating instructions.
Before using the vacuum
cleaner
Attaching the suction hose (see fig. 1)
^ Insert the elbow into the suction
socket until it clicks. Use the inlet
guides to direct insertion.
Removing the suction hose (see fig. 2)
^ Press the release buttons at the sides
of the elbow and lift the hose from the
socket.
Connecting the handle to the suction
hose (see fig. 3)
^ Insert the suction hose into the
handle until it clicks into position.
Connecting the handpiece and
telescopic wand (see fig 4/
^ Insert the handpiece into the
telescopic wand. Use inlet guides to
direct insertion.
^ To release the handpiece from the
telescopic wand press the locking
button (see arrow) and pull the
handpiece away from the telescopic
wand with a slight twist.
Adjusting the telescopic wand
(see fig. 5)
This telescopic wand consists of two
sections which are height-adjustable.
^ Press the adjustment button to
release the tubes and adjust to the
desired height.
Attaching the standard floor brush
(see fig 6)
(depending on model)
^ Insert the wand into the floor brush
and twist until it locks with a click.
To release the floor brush from the
telescopic wand, press the locking
button (see arrow) and pull the wand
out of the floor brush.
Floor brush settings (see fig. 7, 8 + 9)
Observe the cleaning instructions of
the floor manufacturer.
Depending on the floor brush the
following symbols are shown:
–
ö and ä
–
% and )
To clean carpets and area rugs:
^ Press the foot switch marked ö or
%.
To clean hard flooring:
^ Press the foot switch marked ä or
).
Floors with very deep joints and
cracks should be vacuumed using
the floor brush with the bristles out.
en
10