Mazda 8T12-EA-03K - Manual (Page 46)

Black plate (46,1)
3. To get the retractor into the automatic
locking mode, pull the shoulder belt
portion of the seat belt until the entire
length of the belt is out of the retractor.
4. Push the child-restraint system firmly
into the vehicle seat. Be sure the belt
retracts as snugly as possible. Clicking
from the retractor will be heard during
retraction if the system is in the
automatic locking mode. If the belt
does not lock the seat down tight,
repeat this step.
NOTE
Inspect this function before each use of
the child-restraint system. You should
not be able to pull the shoulder belt out
of the retractor while the system is in
the automatic locking mode. When you
remove the child-restraint system, be
sure the belt fully retracts to return the
system to emergency locking mode
before occupants use the seat belts.
5. If your child-restraint system requires
the use of a tether strap, hook and
tighten the tether strap by following the
manufacturer's instructions.
Sedan Anchor
bracket location
Open
Cover
For rear center seat
For rear right seat
For rear left seat
Anchor
bracket
Sedan
Tether strap
position
Tether
strap
2-32
Essential Safety Equipment
Child Restraint
Mazda6_8T12-EA-03K_Edition1 Page46
Friday, December 5 2003 8:54 AM
Form No.8T12-EA-03K