Murphy Centurion Configurable Controller CE-05171N - Manual (Page 23)

CE-05171N page 23 of 44
6.3 Setup Screens and Menus
6 6..3 3..1 1 P Pa as ss sw wo orrd d S Sc crre ee en n
Some settings are password protected, including the setup screens.
This is the first screen seen when the SETUP/ENTER key is pressed.
The password need only be entered once during any editing
session. The password will reset when the editing session is
exited, or is timed-out due to keyboard inactivity.
The cursor begins at the last digit on the right. The user can
adjust the value of each digit with the up/down arrows while
the left/right arrows are used to select the digit to edit.
Passwords are assigned using the MConfigPro software and each
digit can range from zero to nine (except the first digit on the left)
for a total range of 00000 to 65535 for the complete password.
The user will not be allowed to increment the selected digit if it
would result in exceeding range limits.
There are three separate levels of passwords to accommodate
several security needs:
• “Standard” password – Allows access to every feature
except the Super User menu. Valid Standard passwords
can be zero or any number between 100 and 65535. If the
Standard password is set to zero, the result is that anyone
can have read/write access to setup menus.
• “Super User” password – Adds the Super User menu to the
Standard menus. Valid Super User passwords can be in the
range of 100 to 65535. The Super User password can not
be the same as the Standard password.
• “Download Only” password – This Special 35 Jump Code
allows access to a download menu and is set to a fixed
value of 35. This allows a configuration to be downloaded in
the event that the current passwords are lost or no initial
configuration has been downloaded.
If the Standard password is not zero and a password of all zeroes
is entered, the user will have “view only” access.
Inactivity Timeout: Setup procedures must be started and
completed in a timely manner. Note that after 3 minutes
without activity, the keypad returns the default operational
screen and a password must be re-entered to return to the
setup and edit menus.
Password Screen
TM
C C C
FOR SETUP MENUS
00000
ESC-CANCEL
▼▲ ENTER-ACCEPT
▼
▼ ▼
___________________________________
ENTER PASSWORD
___________________________________
_
TM
C C C
Super User Menu Screen
___________________________________
▼
▼
SUPER USER MENU
COM FAIL DISABLE
NO
SETUP T/O DISABLE
CONFIG FAIL DISABLE
RESET FAULT HISTORY
RESET EVENT HISTORY
▼▲ ENTER-EDIT
MORE MENUS
___________________________________
___________________________________
▼ ▼
ESC-EXIT THIS MENU
TM
C C C
Download Only Screen
___________________________________
▼
▼
CONFIRATION DOWNLOAD
COM 1 CONFIG DOWNLOAD
NO
COM 2 CONFIG DOWNLOAD
USB CONFIG DOWNLOAD
FIRMWARE DOWNLOAD
▼▲ ENTER-EDIT
___________________________________
___________________________________