Maxim Manufacturing MS50B - Manual (Page 3)

Never adjust the machine or change attachments until the
engine has been turned off and the spark plug wire discon-
nected. It is possible that the engine could start while mak-
ing an adjustment or repair.
If carburetor adjustment is necessary, stand to one side
and keep feet and hands in the clear while making adjust-
ments.
Keep engine free from accumulations of grass, leaves, or
excessive grease. An accumulation of these combustible
materials may result in a fire.
Store gasoline in a safe container. Store the container in a cool, dry place, not in the house or near heating appli-
ances.
Never store machine with fuel in the fuel tank inside a build-
ing where open flame or sparks are present. Allow engine
to cool before storing in any enclosure.
Keep the machine and fuel container in locked storage to
prevent children from playing and tampering with them.
Maximum operating results and safety can only be expect-
ed if the machine is maintained and operated correctly.
Always refer to operator’s manual for important details if
tiller is to be stored for extended period.
Continued from page 2
IMPORTANT: THIS UNIT IS EQUIPPED WITH AN INTERNAL COMBUSTION ENGINE, AND SHOULD
NOT BE USED ON OR NEAR ANY UNIMPROVED FOREST-COVERED, BRUSH COVERED OR GRASS
COVERED LAND UNLESS THE ENGINE’S EXHAUST SYSTEM IS EQUIPPED WITH A SPARK ARREST-
ER MEETING APPLICABLE LOCAL LAWS (IF ANY). IF A SPARK ARRESTER IS USED, IF SHOULD BE
MAINTAINED IN EFFECTIVE WORKING ORDER BY THE OPERATOR.
IN THE STATE OF CALIFORNIA A SPARK ARRESTER IS REQUIRED BY LAW (SECTION 4442 OF
THE CALIFORNIA PUBLIC RESOURCES CODE). OTHER STATES MAY HAVE SIMILAR LAWS. FED-
ERAL LAWS APPLY ON FEDERAL LANDS. SEE YOUR AUTHORIZED SERVICE CENTER FOR A
SPARK ARRESTER.
WARNING
The engine exhaust from this product contains chemicals know to the State of
California to cause cancer, birth defects, or other reproductive harm.
Specifications
Engine: Briggs & Stratton 4 cycle
5.5 Intek, 1264120226E1C1032 -- Horiz.
3.5HP #91202 Type 1264
Air Cleaner: Replaceable Paper Element
Fuel Tank: 3 Quarts
Throttle: On Handle Panel
Transmission: Roller chain and sprocket,
sealed and running in oil.
Tines: 14” slasher, self-sharpening
Tine Speed: Approximately 78 RPM maximum
Tilling Width: 14” to 26” standard
Tilling Depth: Up to 12”
Handle: 14 gauge seamless tubular steel with
braces
Clutch: Hand controlled belt tightener
Frame: All steel, welded and braced
Wheels: 10 x 1.75
Approximate Shipping Weight:
5hp -- 134 lbs.
3hp -- 125 lbs.
Contents
Safe Practices for Garden Tillers 2-3
Specifications 3
Set-Up Instructions 4-5
General Information 5
Operation 6
Adjustments 7
Maintenance 7
Parts Lists 8-11
Warranty 12
Transmission Assembly
Illustration 4
10 3