MTD 340 Thru 390 User Manual
Operator’s manual, Front tine tillers
Table of contents
Document Outline
- NOTE: This operator’s guide covers three different model tillers. Model series 340 thru 345 have forward tine drive only. Model ...
- NOTE: References to right or left side of the tiller are determined from behind the unit in the operating position.
- NOTE: If your tiller’s tailpiece and depth stake has been already assembled before shipping, proceed to the next section. If it is unassembled, follow the steps below.
- NOTE: If your tiller’s clutch control cable(s) have been already assembled before shipping, proceed to the next section. If unassembled, follow the steps below.
- NOTE: Do not overtighten control cable. Too much tension may cause it to break when engaged.
- NOTE: Never engage both the forward and reverse tine drives at the same time. Engaging both forward and reverse tine drives at the same time could damage the belt drives and cause the engine to stall.
- NOTE: Primer may be needed to restart a warm engine after a short shutdown.
- NOTE: If engine fails to start after three (3) pulls, push primer two (2) times and pull starter rope again.
- NOTE: See your engine manual packed with your unit for more detailed instructions.
- NOTE: When storing any type of power equipment in an unventilated or metal storage shed, care should be taken to rustproof the equipment. Using a light oil or silicone, coat the equipment and especially any springs, bearings, and cables.