Miller Electric 301 G - Manual (Page 25)

OM-4411 Page 21
5-9. Adjusting Wire (MIG) Weld Puddle Consistency
Ref. 803 100
3/8, 7/16 in
Tools Needed:
1
2
3
Y Stop engine and let cool.
Stabilizer DC-Z is factory connected to
suit most Wire (MIG) welding applica-
tions.
To change Wire (MIG) weld puddle con-
sistency, proceed as follows:
Remove cover and right side panel.
1
Stabilizer DC-Z
2 Wire /CV Weld Output Terminal
3 Stabilizer Leads 29, 28, And 27
Lead 29 − provides stiffest weld
puddle
Lead 28 − provides wetter weld
puddle (for mild steel)
Lead 27 − provides wettest weld
puddle (for stainless steel)
Lead 29 is connected to the Wire/CV
weld output terminal at the factory.
Disconnect lead 29 from the Wire/CV
weld output terminal.
For wetter weld puddle (for mild
steel):
Remove insulated sleeving from lead
28. Connect lead 28 to Wire/CV weld
output terminal, reusing hardware. Insu-
late lead 29 with sleeving removed from
lead 28. Secure sleeving with cable ties.
For wettest weld puddle
(for stainless steel):
Remove insulated sleeving from lead
27. Connect lead 27 to Wire/CV weld
output terminal, reusing hardware. Insu-
late lead 29 with sleeving removed from
lead 27. Secure sleeving with cable ties.
Reinstall side panel.