Miller Electric 301 G - Manual (Page 24)

OM-4411 Page 20
5-8. Remote Receptacle Information
Engine runs at weld speed (3000 or 3600 rpm) whenever a device connected to
the remote receptacle is running.
NOTE
Socket* Socket Information
A J
24 VOLTS AC A 24 volts ac. Protected by circuit breaker CB5.
A J
B
K I B Not used.
C L N H
D M G
115 VOLTS AC I 115 volts ac. Protected by fuse F2
D M G
E F J Not used.
A/V
C Output to remote control: 0 to +10 volts dc output
to remote control in Stick and TIG modes. +10
volts dc output to remote control in Wire mode.
A/V
AMPERAGE
VOLTAGE
D Remote control circuit common.
VOLTAGE
E DC input command signal: 0 to +10 volts dc from
min. to max of remote control with front panel V/A
control at max.
GND
G Circuit common for 24 volt ac circuits.
GND
K Chassis common.
*The remaining sockets are not used.
Notes