MB QUART Q1.1500D - Manual

System Design
The success of any car stereo system relies on several factors, such as
the system design, execution of the installation, and system setup. Please
remember that any system is only as good as its weakest link.
Please remember that higher power systems are not necessarily useful
purely for high sound pressure levels, but also to establish a headroom
capability, to reproduce musical peaks cleanly without distortion.
Lower power amplifiers will clip earlier than their more powerful cousins,
and cause loudspeaker failure when overdriven, due to the harmonics
generated by a clipped signal, thus overheating voice coils.
Amplifiers should be mounted with the fins running horizontally for best
convection cooling, to minimize overheating. Purchase the best quality
RCA cables you can afford, for reliability and less engine noise
interference in the audio system.
It is highly recommended that the amplifier be mounted to a board of MDF
or other solid structure using the 4 mounting screws provided. Avoid
mounting the amplifier to metal as this can introduce noise and other
unwanted issues. When mounting the amplifier, ensure that it is mounted
HORIZONTALLY, as shown in the diagram above, for optimal heat
dissipation. Mounting amplifiers to speaker enclosures is not
recommended as this can cause damage to the amplifier components.
When choosing a location for mounting the amplifier, ensure that you
check for clearance from wires, gas tank, electrical devices and brake
lines etc.
Congratulations!
By purchasing an amplifier from MB Quart, you have decided on a product
of the highest technical quality. MB Quart wishes you great enjoyment with
your amplifier. Should you have any questions about this system or other
MB Quart products, please email us at [email protected]
Installation Manual
WOOD
Q
Q4.80 / Q4.150 / Q1.1500D
CROSSOVER
INPUT MODE
4CH 2CH
CROSSOVER
PROTECT
POWER
LEVEL
CLIP INDICATOR CLIP INDICATOR GREEN-
PRE CLIP GREEN-
PRE CLIP AMBER- SOFT CLIP AMBER- SOFT CLIP RED- HARD CLIP RED- HARD CLIP
LEVEL
BASS BOOST BASS BOOST
BASS FREQUENCY
HIGH PASS
LOW PASS
MULTIPLIER
FREQUENCY
FILTER SLOPE
HIGH PASS CHANNELS 1&2 CHANNELS 3&4
9V
0dB
9V
0dB
30Hz
15Hz
40Hz
0.2V
12dB
X15 X1
6dB 12dB
DUPE HP-FULL
(3&4) LP-BP LP-BP HP-FULL
MONO STEREO
(x1) 20Hz 300Hz (x15) 300Hz 4.5KHz
0.2V
12dB
80Hz
1KHz
4.5KHz