Mr. Coffee ECMP2 - Manual (Page 6)

Before Using Your Mr. Coffee Espresso Maker
Please refer to page 5 for diagram of par
ts.
1. power switch off and unplug the machine from the electrical
2. Wash the wa
ter reservoir, filter basket and filter holder in a mixture of
mild detergent and water. Rinse each thoroughly and replace into
machine.
3. To rinse the Inside of the mach ine, follow steps for “How to Brew
Espresso” on pages 6-7, using waler only.
How To Brew Espresso
Please refer to page 5 for diagram of parts. First unwind The electrical cord
from the bottom 0f your machine.
Filling the Water Tank...
1.
2.
3.
4.
5.
6.
7.
Remove the water reservoir by opening the lid and lifting up the reservoir
handle. Fill the water reservoir with fresh, cold water to the top of the
reservoir (29 ounce capacity).
Never fill below the minimum line level indicated on the, outside of the
reservoir. Insert the water reservoir into the machine. If the water
reservoir is not Inserted properly Into the machine, the valve on the
bottom of the reservoir will not be activated. The water reservoir
lid will close only
opened. Do not
If the reservoir is prop erly Inserted and the valve is
machine.
force the wa ter container In any other way into the
The pump must be primed whenever the machine is being used for the
first time or if not used In a long time. This procedure prepares the
pump and fills the water boiler with water.
plug the power cord Into an eteclric outlet.
PIace a frothing pitcher or large cup
water under the frothing tube. Sub
(with 16 ounce capacity) half full of
the water.
merge the tip of the frothing tube in
Turn-the machine ON. Leave the brew switch in the OFF position.
Turn the steam selector control nob to the ON position. After a few
seconds a HOT stream of water will emerge from the frothing tube.
Allow one cup of water to flow through the frothing tube.
Shut the steam selector control knob OFF.
Your espresso/cappuccino maker is now
primed.
Pre
1.
2.
paring the Coffee...
Remove the filter holder b y
l/4 to the
grabbing
handle and sliding left. Th
the filter
e f ilter
holder will now release.
askets (1 =for Place either one of the fil
ter b
one l-1/2 ounce cu
1-1/2 ounce cups o
of espresso: 2=for two
es
holder. See ure 1.
resso) lnto the filter
spoon,
ilter
wtlh fresh fine
flat spoon per cup). Do not the
round espresso coffee (one
cause
grounds
Ing or over flow. Tamp (tap
basket. This might
lightly, but do not pack) the
-the flat disc at the end of
the handle of the
spoon. Clean any excess coffee from the rim of the filter holder. hls
will assure proper fit under the brew head.
3. Make sure filter retainer clip Is away from the filter baske
t.
Make sure the steam selector control knob is in the OFF position. Turn
the machine OFF and make sure the brew switch is in the “0” OFF posi-
tion.