Philips Magnavox CC13B1MG - Manual (Page 8)

8 Turning On the TV/VCR
Before you turn on the TV/VCR, make sure batteries are in the
remote control and the TV/VCR is hooked up correctly.
The instructions on this page work only when you turn on the
TV/VCR for the first time.
1
Press the POWER button. The TV/VCR will come on and the
screen shown below will appear.
2
Press the PLAY/K button or the STOP/L button to select
English or Spanish on-screen displays and menus.
3
Press the MENU button. The screen shown below will appear.
4
Press the FF/SEARCH/B button to begin automatic chan-
nel setup. The TV/VCR will memorize all available channels.
When channels are set, CHANNELS ARE SET will appear on the
screen briefly. Then the TV/VCR will go to the lowest channel
programmed.
(If you try to set up channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on the
screen. Connect an antenna or cable to the ANT(enna) jack on
the TV/VCR, then press the FF/SEARCH/B button again. You may
need to follow the steps on page 10 instead.)
CONNECT ANTENNA OR CABLE
TO TVCR
THEN PRESS B
TO END PRESS EXIT
SELECT LANGUAGE
> ENGLISH ON
ESPAÑOL
SELECT KL OR
PRESS MENU TO CONTINUE
5
Use the CHANNEL K/L buttons or the Number buttons
on the remote control to select a TV/VCR channel. Use
the VOLUME K/L buttons to adjust the sound.
• If you do not see any on-screen dis-
plays when you turn on the TV/VCR,
check your hookups, then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine-10 to select a language and
set up channels.
• To skip step 2, press the MENU
button. All on-screen displays will be
in English. To skip step 4, press the
STATUS/EXIT button. Channels will
not be set up, and CHANNELS
NOT SET will appear on the screen
briefly.
• You cannot set up channels if you
are using a Cable Box.
• Line Input mode will always be
stored in the TV/VCR’s memory as
channel 00. When you select chan-
nel 00, A/V IN will appear on the
screen briefly. Press the CHANNEL
K
/L buttons or the Number but-
tons to select another channel.
Helpful Hints
1
2
3
5
4
POWER CLEAR STATUS/EXIT
1 2 3
4 5 6
7 8 9
0
CHANNEL
SLEEP/WAKE UP
MUTE SPEED VOLUME
REW/SEARCH PLAY/ FF/SEARCH
REC/OTR PAUSE/STILL STOP/
ALT.CH
MENU
MEMORY