Multiquip Trash Pump QP3TY - Manual (Page 15)

QP3TY TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #2 (11/15/10) — PAGE 15
QP3TY — BASIC ENGINE
ENGINE COMPONENTS
Figure 4 illustrates the location of the major components of the
engine. Each component is described below:
1. Fuel Filler Cap – Remove this cap to add diesel fuel to the
fuel tank. Make sure cap is tightened securely. DO NOT
overfill.
2. Fuel Tank – Capacity is 3.5 quarts (3.3 liters) of diesel
fuel.
3. Air Cleaner – Prevents dirt and other debris from entering
the fuel system. Remove wing-nut on top of air filter
cannister to gain access to filter element.
4. Muffler – Used to reduce noise and emissions.
5. Recoil Starting Handle (pull rope) – Used to start engine.
6. Recoil Starter – Manual-starting method. Pull the starter
grip until resistance is felt, then pull briskly and smoothly.
7. Oil Filler Cap / Dipstick – Remove this cap to add oil to the
engine crankcase. Read dipstick to determine if oil level is
low. DO NOT overfill.
8. Oil Drain Plug – Unscrew plug to drain oil from engine
crankcase. Dispose of oil in a safe manner.
9. Decompression Lever – Press down before starting
engine. To prevent damage to engine, DO NOT use for any
other purpose.
10. Fuel Cock – Controls the flow of diesel fuel to the carburetor.
Must be in the ON position when starting and running the
engine.
Figure 4. Engine Controls and Components