Metrologic Instruments FOCUSE IS1650 - Manual (Page 36)

32
D
EFAULT
S
ETTINGS
Many functions of the scanner can be “configured” – that is, enabled or disabled.
The scanner is shipped from the factory configured to a set of default conditions.
The default parameter of the scanner has an asterisk (*) in the charts on the
following pages. If an asterisk is not in the default column then the default setting
is OFF or DISABLED. Not every interface supports every parameter. If the
interface supports a parameter listed in the charts on the following pages, a
check mark ( ) will appear.
PARAMETER DEFAULT RS232
IBM 46XX
RS485
KBW
&
KEYBOARD
USB
Multi-Try Trigger, Out-of-Stand
Presentation Mode, In-Stand *
Presentation Mode, Out-of-Stand *
Continuous Trigger
Single Trigger
Aiming in
Trigger and Continuous Modes
*
Aiming in Presentation Mode *
Long-Range In-Stand *
Short-Range In-Stand
Long-Range Out-of-Stand *
Short-Range Out-of-Stand
UPC/EAN *
Code 128 *
Code 93 *
Codabar *
Interleaved 2 of 5 (ITF) *
MOD 10 check on ITF
Code 11
Code 39 *
Full ASCII Code 39
PDF *
Data Matrix
QR Code