Maytag MER5875RAF - Manual (Page 9)

8
Control Panel
The control panel is designed for ease in programming. The display window on the control shows time of day, timer and oven functions.
Control panel shown includes Convect and other model specific features. (Styling may vary depending on model.)
Using the Touchpads
• Press the desired pad.
• Press the number pads to enter time or temperature.
• Press the Autoset 0 pad to enter temperature.
• A beep will sound when any pad is touched.
• A double beep will sound if a programming error occurs.
A Bake Use for baking and roasting.
B Broil Use for broiling and top browning.
C Clean Use to set self-clean cycle.
D Convect Roast Use for convection roasting.
E Delay Programs the oven to start baking at
a later time.
F Number Pads Use to set time and temperature.
G Autoset Use to quickly set temperatures.
H Keep Warm Use to keep cooked food warm in oven.
I Convect Bake Use for convection baking.
J Cook & Hold Bakes for a preset time, then holds
food warm for 1 hour.
K Favorite Use to set and save a specific Cook &
Hold procedure.
L Timer Sets Timer.
M Clock Use to set time of day clock.
N Oven Light Use to turn the oven light on or off.
O CANCEL Cancels all operations except Timer
and Clock.
A B C D E F G
H I J K L M N O
Note: Four seconds after pressing the number pads or
the Autoset 0 pad, the time or temperature will automati-
cally be entered. If more than 30 seconds elapse between
touching a function pad and the number pads or the
Autoset 0 pad, the function will be canceled and the
display will return to the previous display.
Oven Cooking
cont.
Clock
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is set at the factory for the 12-hour format.
To change the clock to
24-hour format:
1. Press and hold the CANCEL and
Favorite pads for three seconds.
• 12 Hr flashes in the display.
2. Press the Autoset 0 pad to select 24
Hr; press again to select 12 Hr.
3. Set the time of day following the directions
in the To set the Clock section.
To set the Clock:
1. Press the Clock pad.
• The time of day flashes in the display.
2. Press the appropriate number pads to set the time of day.
• Colon flashes in the display.
3. Press the Clock pad again or wait four seconds.
• The colon will remain on.
When electrical power is supplied or after a power
interruption, the last clock time before power was interrupted
will flash.