MicroBoards Technology Quic Disc QD-52 - Manual (Page 9)

9
1. Copy
Copying – 52x 18%
150.4MB 01:15
2. Test
Testing – 52x 18%
150.4MB 01:15
3. Test & Copy
Testing – 52x 18%
150.4MB 01:15
1.0 Copy
OK: 01
2.0 Test
OK: 01
Functions
There are 9 different functions for the QD-52 duplicator: Copy, Test, Test & Copy, Verify,
Compare, Prescan, Disc Info, Edit Track and Setup. For the Setup options, please refer to page
15.
Copy ( NOTE: For CD+G duplication, please see pages 18-20)
The Copy function is used to copy our master disc to the blank media, CD-R or CD-RW. The
QD-52 duplicator will be in Copy mode when it is turned on. The display will read:
Place your master disc into the TOP CD reader drive.
Place your blank media into the BOTTOM CD writer drive.
Press the ENT button on the controller interface.
The data will now be copied to the blank disc.
When the job is completed, the recorded disc will be ejected from the BOTTOM drive.
The display will read:
Test
The Test function is used to simulate copying our master disc to the blank media,
CD-R or CD-RW. To use the Test function, press the ▼ button on the controller
until Test is displayed:
In Test mode, the blank media will remain blank and can be used again.
Place your master disc into the TOP CD reader drive.
Place your blank media into the BOTTOM CD writer drive.
Press the ENT button on the controller interface.
The duplicator will now simulate writing to the blank disc.
When the job is completed, the recordable disc will be ejected from the BOTTOM drive.
The display will read:
Test & Copy
The Test and Copy function will perform both operations, one after the other. If the Test portion
passes without errors, the system will automatically start the Copy process.
To run the Test and Copy function, press the ▼▲ buttons until the
display reads:
Place your master disc into the TOP CD reader drive.
Place your blank media into the BOTTOM CD writer drive.
Press the ENT button on the controller interface.
The duplicator will now simulate writing to the blank disc.