MGE UPS Systems AmpMeter PDU - Manual (Page 5)

2. Installation
Before installation, refer to the following lists to ensure that you have all the items shipped with the unit as well
as all other required items.
Standard Accessories
• Mounting hardware - two removable flanges with four M4 screws and two mounting L-brackets with nut
plates and four sets of screws and washers.
For remote monitoring units only:
• RJ45 to RJ45 crossover cable
• RJ45 to DB9F serial port adapter (for connection to standard DB9M DTE serial port)
Additional Required Items
• Phillip screwdriver
• Screws, washers and nuts to attach the unit to your rack
Equipment Overview
• The Input Current LED(s) displays the current load for each infeed or electrical phase per infeed.
• Each Branch Circuit / electrical phase is color-coded for easy identification.
• The power inlet/cord(s) connects the PDU to the electrical power source.
• Two RJ45 connectors for Serial (RS-232) and Ethernet connection (remote monitoring units only).
F 2
L E D 1 F 1
L E D 2
Imm er Ne tzle itun g
aus kup pe ln v or
den Au fm ach en um
ele ktri sch en Sch lag
zu ve rm eid en.
Alw ay s d isc onn ect
the po we r su ppl y
co rd b efo re ope nin g
to avo id e lec tric al s ho ck.
Afi n d ' é vite r le s c hoc s
éle ctr iqu es , d éb ran che z
le c ab le éle ctri que
av ant d'o uvr ir.
To pre ve nt f ire
rep lac e w ith sam e s ize
and typ e f use on ly
CA UT ION
F 2 (B ra nc h 2 )
F 1( B ra nc h 1)
Bran ch 2
Bran ch 1
Inpu t Curr ent
Am pM ete r PD U
ww w.m geup s.com
U
• Two mini RJ11 connectors for Temperature/Humidity sensors (remote monitoring units only).
PS Y E
M G E S ST
MS
UPS SYST EMS
M G E
2
1
Sen sor
Sm art C DU
www .mge ups.c om
1
1
3
2
1
2
3
3
2
1
A
B
I I I
1 Power Input
2 Input Current LED
3 Ethernet / RS232 Ports
4 Temperature / Humidity Ports
1
1
2
2
4
3
2
1
Figure 0.1 AmpMeter PDU Views
301-0399-3 Rev B. - Page 5